Simplus Full Face CPAP Mask with Headgear

Compatibility:

This mask is compatible with all CPAP machines except for the AirMini.

Mask Type: Full Face

Headgear / Frame Sizes:

• Small
• Medium/Large

Suggested Replacement Schedule:

Your Simplus Full Face Mask cushion will last approximately six months. You should consider replacing your cushion if you notice an increase in leaks, or if you have to overtighten to get a good seal.

Headgear Included: Yes

Replaceable Cushion: Yes

Cushion Type: Silicone

Good For:

• Mouth Breathing

Sleep Position:

• Back
• Side

Breathing Preference: Combo

Product Warnings:

The Simplus Full Face CPAP Mask doesn't contain any rubber latex.

Your Simplus Full Face Mask cushion will last approximately six months. You should consider replacing your cushion if you notice an increase in leaks, or if you have to overtighten to get a good seal.

Cleaning Tips

1. Separate the mask cushion from the frame and remove the headgear.
2. Wet a paper towel with a mix of mild soap and water, and gently scrub the cushion and forehead pad. Make sure to remove any debris that may have collected.
3. Set the cushion aside to air dry, but don’t place it in direct sunlight.

Headgear Cleaning Tips

1. Wet the headgear with water.
2. Apply a little mild soap to the headgear.
3. Gently scrub the headgear, and rinse with clean drinking water.
4. Set the headgear aside to air dry, but don’t place it in direct sunlight.

PLEASE NOTE: Do not wash the headgear in a clothes washer or dry it in a dryer. Do not iron the headgear.

Fitting Tips

It takes only three steps to fit the Simplus CPAP mask the first time:

1. With one headgear clip locked on to the frame, place the cushion over the nose and mouth and slide the headgear over the head.
2. Lock in the second headgear clip.
3. Adjust the headgear straps from top to bottom, starting with the top buckle and working down to the headgear clip straps.

Headgear Size Note: The Simplus Headgear is available in two sizes: Small and Medium/Large. The size Small CPAP mask comes packaged with the Small headgear. The Medium and Large sizes come packaged with the Medium/Large headgear.

Cushion Note: The cushion of the F&P Simplus is attached to an acrylic shell and they cannot be separated from each other. This is meant to be permanently attached for effortless assembly. Any size Simplus Cushion can be used with the Simplus Frame.

Where do I find the size?

The mask frame does not have an identifiable size because it offers a universal fit to each of the Simplus Full Face Mask cushions.

The size of the cushion can be found on either side of the full face cushion. Hold the mask with the elbow facing the user. Then, turn the mask to the left or right to view the profile of the full face cushion. Near the middle of the cushion, the user will see a clear, embossed letter imprinted into an indention beginning at the bridge of the nose. The letter represents the size of the full face cushion.